Compensator Housing adapter installation

The installation of this adapter is very simple, there is only one screw holding it, please take your time and be patience, do not tight the screw until you have well positioned this adapter.

To install this adapter the 12 gram Co2 extender adapter is required.

1- Install the adapter but don’t tighten the screw yet, this step is very important.

2- Move the adapter and position it well, making sure the barrell is aligned.

3- Once positioned to the right position hold it with your fingers on both edge sides then carefully tighten the screw using a 1.5 mm hex tool, DO NOT OVERTIGHTEN to prevent damage to the Co2 extender.

For the BYRNA LE model, after the installation make sure the barrel is aligned well before installation, this step is very important to prevent the barrel from getting stuck.

Please note that there will be a small gap between the launcher after tightening the screw, which is normal, but that does not affect the function of the launcher as long as the barrel is aligned.